| |
6-29.
What are the proper procedures
for preheating the flatwork
ironer?
1.
Keep the main steam valve
partially open for 20
minutes and then open it
all the way for another 25
minutes
2.
Open the steam valve
one-half a turn first and
gradually allow steam to
enter the cylinder;
continue to open the steam
valve slowly until it is
open all the way
3.
Turn the steam valve on all
the way and allow 45
minutes for the cylinder to
heat
4.
Bring the cylinder in
contact with the padded
rolls, keep the main steam
valve partially open for 10
minutes, and then turn the
steam on all the way
6-30.
Which of the following actions
should you AVOID to prevent
damaging the variable speed
mechanism?
1.
Setting it to the lowest
speed while warming the
flatwork ironer
2.
Engaging the compression
roll while the ironer is on
3.
Changing the speed of the
ironer while the ironer is
on
4.
Decreasing the speed of the
ironer while the ironer is
off
6-31. What are the proper procedures
for securing the flatwork
ironer at the end of the day?
6-32.
6-33.
1.
2.
3.
4.
Turn the machine off and
raise the compression roll
so the machine can cool for
30 minutes
Close the steam supply,
raise the compression roll
and allow the machine to
run for 20 or 30 minutes
without steam to allow it
to cool properly before you
shut the power off
Turn the power off, secure
the steam, and remain in
the laundry until the
ironer cools down
Raise the compression roll
and allow the-machine to
run for 10 to 15 minutes,
gradually turning the steam
off to allow the machine to
cool, and then shut it off
The compression roll on the
flatwork ironer should be
raised when the ironer is left
unattended for what minimum
time period?
1.
5 minutes
2.
10 minutes
3.
15 minutes
4.
20 minutes
What is the purpose of feeding
the flatwork into the ironer
wrong side up?
1.
To prevent scorching the
right side
2.
To prevent wearing through
the smooth side
3.
To exert more pressure on
the rough side of the
material
4.
To give a smooth finish to
the right side of the
material
52
|
