6-34. What  procedure  should  be  used to feed large items into a 75-inch  ironer? 1. One person only feeds the items into the ironer 2. Two persons feed all the items into the ironer 3. Two  persons  feed  the  large items into the ironer folded 4. Three  persons  feed  all  the items into the ironer 6-35. Into what part of the cylinder of  the  flatwork  ironer  should small items be fed? 1. Center 2. Left end 3. Right end 4. Along  the  entire  length Learning  Objective: Identify the  various  laundry  presses used  in  the  shipboard  laundry, the  controls  used  to  operate them, and the safety precautions  applicable  to  their use. 6-36. What part of the press is used as  your  worktable  when  you press  uniform  items? 1. The  rigid  metal  frame 2. The buck 3. The press head 4. The  manifold 6-37. What type of press would be best  suited  for  pressing flatwork  when  a  flatwork  ironer is  not  available? 6-38. What  is/are  the  purpose(s)  of using the spray gun with the laundry  press  to  press  uniform articles? 1. To keep the laundry press pad and cover cool 2. To  prevent  articles  from sticking to the laundry press head 3. To  compensate  for  moisture loss while the other parts of the uniform are pressed 4. All of the above 6-39. What  control  button(s)  must  you depress  to  make  the  laundry press head lower onto the items you  are  pressing? 1. Both red buttons 2. Both  green  buttons 3. One of the green buttons only 4. One green button and one red button 6-40. How do you release the laundry press head from the item being pressed? 1. By pushing one or both of the green buttons 2. By pushing both red buttons 3. By pushing one of the red buttons 4. By pushing one red button and one green button 1. A taper press 2. A triple head press 3. A sleeve press 4. A  rectangular  press 53