A. B. C. D. E. F. G. H. I. J. K. L. STEPS  IN  OPERATING THE  WASHER  EXTRACTOR Turn off the control switch. Check  and  securely  latch the door to each cylinder. Energize  the  control switch,  making  sure  no other  switches  are energized while doing so. Close the outer shell door. Open the shell door. Load the washer extractor. Rotate  the  cylinder  by depressing  the  jog  switch with  the  forward  or  reverse switch  to  adjust  each cylinder door for loading. Open the cylinder door. Add  the  required  supplies to the automatic dispenser. Mark on the washer with chalk  the  contents  of  each pocket. Adjust  the  drum  control disk. Energize  the  control switch,  master  switch,  and timer switch in that order. Figure  5A IN  ANSWERING  QUESTION  5-66, REFER TO FIGURE 5A. 5-66. Figure 5A contains some of the steps  used  in  the  automatic operation of the Dyna Wash washer  extractor,  but  not necessarily  in  the  correct order. In what order should the steps be taken? 1. C, E, G, H, F, A, B, D, J, I,    L, K 2.  E,   C, G, A, H, F, J, B, D, I, K, L 3.  K,   L, J, E, A, G, H, F, B, D, I, C 4. L, K,   I, A, E, G, H, F, J, B, D, C 5-67. 5-68. 5-69. 5-70. 5-71. What  safety  precautions  should you  take  when  unloading  the washer  extractor? 1. Turn the controls off before placing your hands inside the washer cylinder or shell 2. Line up the openings in the shell  and  cylinder 3. Use the safety switches 4. Secure the door latches When should you use the manual mode  when  washing  clothing? 1. When the workload is very heavy 2. When  washing  heavily  soiled clothing 3. When  the  automatic  timer  is inoperative 4. All of the above What is the ideal steam pressure  for  operating  the washer  extractor? 1. 200 psi 2. 120 psi 3. 100 psi 4. 80 psi When  loading  the  Dyna  Wash washer  extractor,  you  should divide the wash load into three piles. The  weight  difference between each of these piles should  not  exceed  what  percent? 1. 5% 2. 10% 3. 15% 4. 25% Which  of  the  following  safety precautions  should  you  take before opening the outer shell door  to  the  washer  extractor? 1. 2. 3. 4. Make sure the control switch is on Open the shell door while the cylinder is moving only when  all  switches  have  been de-energized De-energize  all  switches and wait for the cylinder to come to a complete stop When  the  signal  switch lights and sounds the bell, open  the  programmer  door and then the shell door 47