| |
119.39.1
Figure 6-10.-Lays 1, 2, 3, and 5 for pressing enlisted men’s jumpers.
Ajax model is illustrated in figure 6-12. These air
finishers make jobs in large dry-cleaning plants
quicker and more efficient.
Controls and Indicators
The controls and indicators you will be
concerned with are illustrated in figure 6-13.
Table 6-1 illustrates the purpose and use of these
controls and indicators. Controls and indicators
may vary between models; however, the
operating principle is the same. Always refer to
your technical manual for correct operating
procedures.
Operation of the Steam Air
Finisher
To eliminate problems, you should always
operate the air finisher in the automatic mode.
During automatic operation, the dura-tion of the
steam and hot air cycles is con-trolled by the
steam timer and air timer settings. The amount
of time to set each control depends on the type of
material. For most clothing items set the steam
timer for 12 seconds and the air timer for 15
seconds. If the finisher is set at 0 or above 30 on
either timer, it will not operate.
6-16
|
