| |
continues to rotate until the timer switch is off
or when one of the following occur:
The disk stops until proper water levels are
reached.
The disk stops until correct
temperatures are acquired during
injection.
water
steam
The disk stops while adding supplies from
the automatic dispenser.
The disk stops when the signal goes on.
After the completion of the cycle and when the
signal alarm goes off, the timer switch should be
de-energized to prevent the chart from advancing
again.
PROGRAM CHART
In conjunction with the wash formula, a
program chart is cut according to the Navy wash
formula. These charts, available through the
supply system, are used with the automatic
programmer on the washer extractor to make sure
the Navy wash formula is followed to the letter.
Your local fleet assistance team is available to
provide assistance in cutting the chart. A sample
program chart is illustrated in figure 5-17. Keep
in mind this is a sample chart only and should not
be referenced in cutting your own chart.
Temperature Control
This control on the program chart regulates
the temperature of the water. The desired
temperature of the water in the washer extractor
is controlled by a thermostat located on the
Figure 5-17.—Sample program chart.
5-23
|
