| |
7-36.
When pressing the front portion
of the leg, you must make sure
the trousers are arranged in
what position?
1.
The crotch is at the small
end of the buck
2.
The leg is lying well to
the front of the buck
3.
The outside of the leg is
facing upward
4.
The side seams are lying
one on the other
7-37.
What procedure should you use
to press the collar of an
officer’s uniform coat?
1.
Press the inside of the
collar first and then the
outside
2.
press the sides of the
collar on the large end of
the buck and the center of
the collar on the small end
3.
Press the inside of the
collar center only; leave
the ends alone
4.
Press each side of the
collar with the lapel and
press the center separately
7-38.
When pressing the right side of
the coat back, you should place
the bottom seam at least how
many inches from the front edge
of the buck?
1.
1 inch
2.
2 inches
3.
3 inches
4.
4 inches
7-39.
The enlisted men’s jumper is
always pressed inside out.
1.
True
2.
False
Learning Objective:
Identify
the general procedures for
operating and using the steam
air finisher and automatic
pants topper.
7-40.
The steam air finisher is used
to finish which of the
following items?
1.
Uniform coats
2.
Shirts
3.
Trousers
4.
Linens
7-41.
What control on the steam air
finisher is used to control the
amount of time air is blown on
the clothing article in the
manual mode?
1.
The air control timer
2.
The steam toggle switch
3.
The air toggle switch
4.
The steam control timer
7-42.
What control on the steam air
finisher is used to control the
amount of time steam is blown
through the clothing in the
automatic mode?
1.
The steam control timer
2.
The steam toggle switch
3.
The neon signal indicator
4.
The air control timer
7-43.
In the automatic mode, the air
timer on the steam air finisher
should be set for what amount
of time for most clothing
items?
1.
10 seconds
2.
12 seconds
3.
15 seconds
4.
20 seconds
7-44.
In the automatic mode, what
will occur if the steam or air
timer on the steam air finisher
is set for 0 or 30?
1.
The steam air finisher will
not operate
2.
The article will be
finished slightly wet
3.
The article may become
damaged
4.
The alarm will sound to
alert the user to change
the timer
7-45.
The steam air finisher will
stop during the automatic cycle
any time the operator steps on
the foot switch.
1.
True
2.
False
63
|
